Vermont castings sdv30r manual

Next Page. Thank you and congratulations on your purchase of a Vermont Castings stove. Main- tain the manifold pressure at 3. Inlet Maximum Page 9 Vent Termination Clearances Your stove is approved to be vented either through the side wall, or vertical through the roof.

Page Termination Clearances Termination Clearances Termination clearances for buildings with combustible and noncombustible exteriors. The fan kit includes a Blower Assembly and a Rheo- stat Assembly, connected by a cable.

Follow the vent component instructions exactly. For U. Install the Restrictor Plate. Twist lock as before. Install the storm collar and seal around the joints.

Add additional vent lengths to achieve the proper overall height. Apply cement to the inner and outer termination col- lars and install the terminal cap. Use Four 8dNails ST Page Install The Vent Pipe Install the Vent Pipe Apply a bead of sealant around bottom end of inner starter pipe found in bag with logset and attach to stove. Since some municipalities have additional local codes, be sure to consult your local authority. In Canada; Page Complete The Assembly 8.

The air shutter is located on the bottom of the burner to the left. Unfasten the two nuts holding the shutter in place. Check the table below for the appropriate gauge ther- mostat wire to use for the length of lead required in your installation.

Page Operation The Stardance is operated with the operable door front plate in place with the doors open or closed. To open the front doors, insert the handle into the door latch stub and turn it to the left and up. This heater has a pilot which must be lit manu- ally. NOTE: The antenna should hang in free air away form grounded metal. Operation 1.

Does the transmitter dis- play the room and tempera- ture setting? If the setting is above room temperature on the transmitter, does the main valve and fan turn on? Repair Guides. Accessories for the Vermont SDV I'm looking for a new blower motor for this model as ours is making noises and I'm afraid its going to quit.

Melissa Ckark for model number Sdv30r asked on Hello Melissa, thank you for writing. Unfortunately a replacement Blower Motor does not appear in the parts list for your model. You may want to reach out to Vermont directly to see if they can provide the part number you are looking for.

Please feel free to get back in touch with us if they provide you with a compatible part number. Thank you! Did this question help you? Yes No. Do you have a Honeywell Maxitrol Serial no. If so, how much would it cost? Mary for model number SDV30 asked on Good Day Mary. We do apologize but we were not able to locate the information you requested. For more specialized assistance or to speak with someone about this, we recommend calling the manufacturer of the equipment directly.

They may be able to provide you with the part number that you need. Once you have this information, please feel free to check back with us for pricing and availability information.

Best Regards. Can be turned by hand to on position but can feel friction in doing so. I think a new knob assembly would fix. If you agree please provide part or any suggestion of repair.

Thank You. Phil for model number SDV30 asked on Hello Phil, thank you for your inquiry. The part you described does not appear in the parts list for this model. Please reach out to Vermont directly to obtain the part number you need to order. Thank you. Ask a question.

Ask our experts a question about this part and we will respond as soon as we can. Join our VIP email list to receive money-saving-advice and special discounts. Model Number Recommended. Submit your question. Thank you for your question! Our experts will get back to you as soon as they can. Ask Another Question.